In barrels and bottlesLubricating oilTo the extent that it is possible to store in the warehouse, to prevent the harm of air, the lubricating oil that has been opened must be stored in the warehouse。The oil drum should be lying down, and both sides of the drum should be wedged tightly with wooden wedges to prevent flipping。In addition, the oil drum should always be checked for leakage and whether the surface of the drum is clearly marked。If it is necessary to put the barrel straight, it is appropriate to reverse the barrel so that the lid is down, or the barrel is slightly skewed to prevent precipitation from gathering on the barrel surface and flooding the lid bucket。Water has a bad effect on any lubricating oil。

        From the surface point of view, water is not easy to penetrate into the detailed lid of the barrel and into the oil barrel, but it is not known that the oil barrel stored outdoors is exposed to the sun during the day, and the temperature is cooler at night, which will harm the working pressure of the gas in the barrel;It is slightly higher than the atmospheric pressure during the day and close to the vacuum pump at night。This kind of change in the working pressure at night will cause the "suction" effect, during the day a part of the gas is "exhaled" out of the barrel, and the gas is "sucked into" the barrel at night, if the lid of the barrel is immersed in water, then the water will inevitably enter the barrel with the gas at night, and the water mixed in the lubricating oil is of course very considerable。

        When taking lubricating oil, the oil barrel should be placed on a wooden shelf with a moderate height to width ratio, and the cover of the barrel is matched with a lead point of oil, and a vessel is issued in the lead to prevent dripping。Or put the oil drum straight through the drum cover and insert it into the oil pipeline according to the hand pump。 The lubricating oil stored in the oil storage tank will inevitably contain condensate and waste, which will gather at the bottom of the tank to produce a layer of sludge emulsion, causing the lubricating oil to suffer from environmental pollution。Therefore, the bottom design of the tank should be saucer-shaped or skewed, and the metabolic plug valve should be installed to facilitate the timely discharge of sediment。To the extent possible, the interior of the storage tank should be handled on time。

        The harm of temperature to grease is checked by the large amount of lubricating oil, long-term exposure to high temperatures (such as: sun exposure),Lanzhou lubricant factoryRemind you that the oil components in the grease can be separated, so the grease barrel should be preferentially stored in the warehouse, and the barrel mouth should be placed vertically。The mouth of the barrel containing grease is large, and the waste and water are more easily penetrated, and the lid of the barrel should be tightly covered immediately after taking it。Too low or too high temperature is not good for lubricating oil, so it is not suitable for long-term storage of lubricating oil in low temperature or overtemperature areas。